SKU:
MR55BE-EPR
BRAND:
Kunz
Top of the line 57″ rough cut model with a commercial grade twin cylinder electric start engine and electric clutch blade engagement. Works great behind an ATV, UTV or small tractor for larger acreage jobs.
57" Rough Cut Mower Features:
- 57″ Cutting Width
- 27 HP Briggs & Stratton Commercial Grade Twin Cylinder Engine
- Commercial Grade Deck Assembly
- 4 Tire Design
- Quick Two Crank Height Adjust System
- Height Adjustment Range From 2″ to 8″
- Electric Clutch Blade Engagement
- Conservative 2″ Diameter Sapling Rating
- Pull Directly Behind or Fully Offset to the Side of the Tow Vehicle.
Specification | |
| Class Mower | Rough Cut (Rear Discharge) |
| Engine Make | Briggs & Stratton |
| Engine Model | Commercial Turf OHV (Twin Cylinder with Cyclonic Air Filtration System) |
| Engine HP | 27 |
| Lubrication Method | Pressure with Filter (Low Oil Pressure Shut Off Included) |
| Electric Start (Battery not included) | Yes |
| Number of Mower Blades | 2-30" |
| Blade Tip Speed (ft/min) | 19,000 |
| Cutting Width | 57" |
| Cutting Height | 2.0" - 8.0" By Two Cranks |
| ATV Tongue | Standard (Direct Behind or Full Offset to Either Side) |
| Blade Engagement Clutch | Electric Clutch (200 ft-lb) |
| Deck Metal Thickness | 10 GA |
| Deck Top Plate Thickness | Two Separate 1/4 in. Thick Plates |
| Weight | 580 lbs |
| Pneumatic Front Tires on Casters - Note: Flat Proof Urethance Tire Upgrade Available | 15/600x6, 4 Ply Tubeless |
| Pneumatic Front Tires on Casters - Note: Flat Proof Urethance Tire Upgrade Available | 5.30/4.50x6, 4 Ply Tubeless |
| Fuel Tank Size | 3 Gal. |
| Blade Spindles | |
| Shaft Size | 30mm |
| Bearing # | 6206-2RST |
| Drive Method | 1 B Section "V" Belt |
| Warranty | 1 Year Commercial (Engine - 3 Year Commercial) |
The Wetlands Kit consists of an extra set of tires and mounting brackets
- Great for wetlands or marshy areas that stay wet all year around
- Works well in combination with small personal amphibious vehicles
- Kit more than doubles the tire surface area in contact with the ground
- Easy to install
- Works on all existing and new rough cut mowers
- The rough cut mower will not float with the wetlands kit installed. Water greater than 2-3" in depth should be avoided.
- With the Wetlands Kit installed the minimum cutting height is 3.5"-4".
The Electric Lift Kit consists of all of the mounting hardware, brackets, electric actuator and wiring with remote control panel.
- Great for constantly changing terrain and grass/brush heights
- Allows for quick cutting height changes on the go from the seat of the tow vehicle
- Raise up and over rocks and logs with ease
- Heavy duty 1500 lb linear screw actuator made by Linak
- Works on all existing and new rough cut mowers
The Floatation Kit consists of one additional front and rear tire, mounting brackets and hardware
- Great for mowing around ponds and on rough uneven ground where scalping would normally occur
- Clamping style receiver allows for adjustments from side to side with both the front and rear tires
- Pinned receivers make for quick kit removal when not needed
- Works on all existing and new rough cut mowers
